About

This article describes what a typical PHX flight is like. This is called the standard operating procedure or SOP for short.

Assemble

• Check aircraft components for damage and replace any that are broken or damaged.

• Assemble the aircraft.

• Prepare and install the payload.

• Assemble the CommsBox.

Set Up

• Place the CommsBox.

• Prep iPad/laptop.

Power On & Connect

• Power on the CommsBox and connect to the iPad/Laptop via Wi-Fi or Ethernet.

• Insert the battery into the aircraft.

• Verify aircraft connects to the CommsBox.

• Open Fly PHX.

Plan & Upload Flight

• Plan your flight or open a pre-planned flight plan.

• Upload the flight plan to the aircraft.

Pre-Flight Checklist

• Perform a thorough and complete pre-flight checklist.

• Arm the aircraft after the checklist is complete.

Launch

• Pick up the aircraft and walk to the launch point.

• Shake the aircraft to start the motor.

• Launch the aircraft by taking a few steps forward and throwing the aircraft straight out with the wings level.

Monitor

• Monitor Fly PHX for any warning messages.

• Monitor the airspace to ensure there are no manned aircraft or other drones that may be hazardous to operation.

• Monitor the aircraft is flying the expected flight plan.

Land

• Monitor the Aircraft during the landing pattern.

• Ensure the aircraft is not going to hit any obstacles during final approach.

• Be prepared to use the landing abort feature if necessary.

• Remove the battery from the aircraft after landing, before picking up the aircraft.