| Table of Contents | ||||
|---|---|---|---|---|
|
About
The summary menu is the default landing page for the gear tab. It displays various information about aircraft hardware, sensors, and settings.
Airframe
The airframe category displays system information. The firmware versions of various system components can be found here.
System ID, Airframe type, and vehicle will be the same for all PHX.
Firmware Versions
Firmware Version | Autopilot Firmware. |
Custom Fw | Part of the autopilot firmware version tag. |
CommsBox | CommsBox firmware (not displayed on iOS). |
Senthawk | Also known as the CommsBoard. This is the coprocessor on the autopilot. |
Payload | Camera payload firmware version. Currently only supported for Sentera Double 4K payloads. |
Sensors
The sensors category displays the status of the sensors onboard the PHX.
In most cases the sensors should display as ready.
Users can calibrate the airspeed and compass via the sensors menu in the gear tab.
If the gyro or accelerometer read not ready, try rebooting the aircraft while sitting on level ground and allow to sit for 1 to 3 minutes. If that doesn’t work contact Sentera customer support.
Safety
The safety category displays the current safety settings values and/or actions.
Low Battery Failsafe | Return at critical level, land at emergency level. Not user changeable. |
RC Loss Failsafe | Not user changeable. |
RC Loss Timeout | Not user changeable. |
Data Link Loss Failsafe | Return mode failsafe action. not user changeable. |
RTL Climb To | Aircraft will climb to this altitude when return mode is activated. Not user changeable. |
RTL, Then | Not user changeable. |
Loiter Alt | Not user changeable. |
Land Delay | Not user changeable. |
